AC resonance testing is an indispensable tool throughout the transformer life cycle—from factory acceptance and commissioning to routine maintenance and troubleshooting
Transformers are essential in power systems due to their ability
A battery converts chemical energy into electrical energy by creating a potential difference between two electrodes (anode and cathode) through a chemical reaction.
When a battery is discharged, electrons flow from the anode to the cathode while ions in the electrolyte move to maintain charge balance; when it is charged, the process is reversed.
Vacuum switch vacuum degree tester utilizes an innovative excitation coil and employs the magnetron discharge method to evaluate the vacuum degree of the arc extinguishing chamber without requiring disassembly.
Tan delta testing, also known as dissipation factor (PF) testing, or loss angle testing or dielectric dissipation factor（DDF) , is a diagnostic method used to measure dielectric loss/dissipation factor(tgδ) and capacitance (Cx) and evaluate the insulation condition of electrical equipment, such as cables, transformers, capacitors, and rotating machines.
L'analyse de la réponse en fréquence par balayage (SFRA) est une méthode de mesure importante utilisée pour évaluer l'intégrité mécanique et électrique des transformateurs de puissance. Elle permet de vérifier l'intégrité mécanique des noyaux, des enroulements et des châssis moulés des transformateurs en mesurant la fonction de transfert de tension sur une large plage de fréquences. Chaque réseau électrique présente une réponse en fréquence unique, appelée « empreinte de réponse en fréquence ».
The secondary injection test for protection relays is a common testing method used to evaluate the performance and functionality of protective relays in electrical systems.
There are some tests for insulation oil testing include Breakdown voltage (BDV)test, water content test, acidity test, Dielectric Dissipation Factor test, Interfacial Tension test, Flash Point test, Viscosity test, Relative Density Test, Furan Analysis , Dissolved Gas Analysis (DGA)ect.
This article will talk about the methods of cable testing .The cable testing focused on insulation layer and the leakage , withstand voltage , dielectric loss and partial discharge characteristics of cable insulation
This article introduces battery discharge testing information and the guide of battery discharge capacity test ensure to help you successfully proceed discharge testing to identify the battery state of health (SOH）
English English 
ไทย
Tiếng Việt
العربية
Русский
Italiano
Español
한국어
Português do Brasil
Français
Español de México
Português
Türkçe
Čeština
Español de Argentina
Slovenčina
Dansk
Polski
Deutsch
Ελληνικά
O‘zbekcha
Bahasa Indonesia
Română
